Hi all,
I've tried flushing with the water going in the pipe to the heater on the left hand side of the car looking from the front.
The flow was sluggish, with just some slightly dirty brown water coming out.
There was a very small drip inside the car (NOT ME!), and I suspect that one side of the heater had a build up of pressure inside.
I then reversed the flow, and the water flowed slightly better.
I then came to the conclusion that I may have to keep trying the flow one way, and then the other to see if I could clean the system.
However, when I reverted back again to how I had originally done the flow, the water would not flow at all, and the pressure on the system was such that it was difficult to get a good seal, even with a jubilee clip around the pipe where the water was going in, resulting in the engine bay being sprayed with water.
Any Ideas?. I'm not brilliant on the spannering,and am getting to old to grub around under the dashboard to take the heater matrix out.
Have any other Magneteers come across this problem, maybe I'm just going to have to put up with no heater.
John Barringer